A 20-watt tone beast

Marshall's DSL20CR is an all-tube, twin-channel workhorse capable of conjuring any classic Marshall sound — past or present. Three ECC83s in the preamp section (in concert with the amp's gain/master volume arrangement) give you stunning tone-shaping mojo, and with two EL34s in the engine room, you have enough volume to rule small bars and clubs. Marshall has gone on to fit this little beast with critical upgrades that give you even more control over your sound. A Resonance control (as opposed to the original's fixed deep switch) lets you dial in your preferred amount of low-end girth. You also get studio-grade digital reverb (instead of spring), high and low power settings, and a rear-panel series effects loop. Marshall has even included a 2-way footswitch for channel switching and FX loop on/off.

Tech Specs

• Type:Tube
• Number of Channels:2
• Total Power:20W (10W power setting)
• Speaker Size:1 x 12" Celestion Seventy 80 speaker
• Preamp Tubes:3 x ECC83
• Power Tubes:2 x EL34
• Reverb:Yes
• EQ:3-band EQ, Tone Shift, Resonance
• Inputs:1 x 1/4" (instrument), 1 x 1/8" (aux in)
• Outputs:2 x 1/4" (8 ohm), 1 x 1/4" (internal 16 ohm speaker), 1 x 1/8" (Softube emulated out)
• Effects Loop:Yes
• Footswitch I/O:1 x 1/4" (channel, effects loop)
• Footswitch Included:Yes, 2-button footswitch
• Construction Material:Black Tolex
• Power Source:Standard IEC AC cable
• Height:16.5"
• Width:19.6"
• Depth:9.8"
• Weight:35.9 lbs.