Mozztronics BOD-1 Bass Overdrive

Made in Australia

BOD-1 BASS OVERDRIVE

Most guitar overdrive pedals tailor the sound before and after the clipping stage. This results in a loss of bottom end, as too much bass in an overdriven sound can make the sound “flabby”.

This is the Mozztronics take on a pedal especially for bass players. Our solution is to take the signal from the bass guitar and split it. One path goes straight to the output via the DRY volume control, the other path goes through a high pass filter (to remove the flab from the overdrive) and then to a double clipping stage so as the signal level increases each different clipping stage contributes accordingly. This signal then goes to the CONTOUR circuitry and to the WET volume control. By changing the levels of DRY and WET you can easily vary the balance between the two signals. By keeping the original signal, we retain a warm bottom end and we add in as much dirt up top as is desired.

GAIN controls the amount of overdrive from barely on to full on shred

DRY controls the amount of normal signal from the bass guitar

WET adjusts the amount of overdriven signal

CONTOUR switch to select between bright and normal overdrive

This pedal was lightly used and in very good to excellent condtion.  No Box.